MINK 10 CCP / CCR Termination

Cut cable to length
Score for jacket removal
Tape around cable jacket for abrasion w/ sandpaper
Remove jacket, Gunkie stuff inside, filler strands
Separate, strip, tin, ring out each wire, verify color code
Comb out shield, solder, trim, solder on termination wire
Bead blast connector shell potting area, clean w air/alcohol/air, insert O Ring
Slip connector shell onto prepped cable
Inspect O ring
Put flux on connector insert solder pots
Heat shrink over each wire one - at - a - time, 1/2"
Solder wires into connector insert, pull down heat shrink
Ring out the wire from connector pin to opposite connector pin
Heat shrink the wire and pin 
Suggested pin order: 
  5 6 1 10 3 7 9 2 4 8
Seat connector insert using CCP / CCR connector for alignment
Install Spiralox
Install O Ring
Lacing Tape wires
Ring Out connector pins to opposite connector pins
Ready for potting
Resin 69 / Hardener 31 / Total: 100 grams
Put resin into oven for about an hour
Tape cable jacket at mold entry location ( leak / centering )
Coat bead - blasted metal of connector shell with FL10 / cure 30 - 60 minutes
Coat roughened Urethane jacket with FL20
Put a light coat of FL20 over FL10 on metal shell
Put another light coat of FL20 on the Urethane jacket
Lightly spray cable molds with Mann 200 mold release, wait 10 mins, lightly wipe w Kemwipe
Use clay to build a dam on top of mold surrounding entry into the mold
Take resin out of oven, pour in hardener until scale reads 100 grams
Stir w flat stirrer, getting sides and bottom of container
Slowly pour the mix into the mold, through the center hole, rock the mold, allowing bubbles to exit
Place assembly into pressure chamber / Dog down the top / Pressurize to red line ~ 55 psi
Allow three hours for compound to harden