MVC PS Spin notes:

U60 optoisolator is not needed.  
  Tie ACM+ to K4 -1
  Tie ACM- to B Bus RTN
  
J6 is "vestigial"

Diodes are zeners, not TVS:
  TVS_CDSOT23-T36C			
  D84,D85,D86,D89,D90,D91,D92,D93,D94,D95,D96,D97,D98,D99,D100,D103	
  sot_23_3	
  Digikey	CDSOT23-T36CCT-ND

  Replace with:   
  STS232360B151	
  Digikey: 283-STS232360B151CT-ND

Large common mode choke at SE corner, move it south
  
All VN750 High Side Switches need a 100k 0603 pull-down across pins 1 and 2

Add the Humidity and Pressure sensors to the power board

Add the memory chip to the power board

I2c Addresses:
  U37  is 0x37 ( not 0x1F )
  U119 is 0x69 ( not 0xD2 )
  U120 is 0x6F ( not 0xDE )

Latching relays K3 and K7
  5V_ISO on one side, other to GND thru a FET
  Try 3V version, drive coil w/ 3V3_ISO

RDF Backup Battery return tied to BUS_GND
  s/b GND_ISO

ADC128 Vmon Chip gets added to the Isolated Power side on the MVC_PS pcb
  as well as on the Trig_PPS_PC104 pcb

Environmental Sensing chips move to the MVC_PS pcb

Switching regulator for RDF
  Run off the Non-Isolated Bus
  How to Blue Wire this ?