/**********************************************************************
* $Id$		abstract.txt 			
*//**
* @file		abstract.txt 
* @brief	Example description file
* @version	2.0
* @date		
* @author	NXP MCU SW Application Team/Micromint USA Support
*
* Copyright(C) 2010, NXP Semiconductor
* All rights reserved.
*
***********************************************************************
* Software that is described herein is for illustrative purposes only
* which provides customers with programming information regarding the
* products. This software is supplied "AS IS" without any warranties.
* NXP Semiconductors assumes no responsibility or liability for the
* use of the software, conveys no license or title under any patent,
* copyright, or mask work right to the product. NXP Semiconductors
* reserves the right to make changes in the software without
* notification. NXP Semiconductors also make no representation or
* warranty that such application will be suitable for the specified
* use without further testing or modification.
**********************************************************************/
  
@Example description:
Purpose:
	This example describes how to use SPI to read SD card's CID register 
Process:
	SPI configuration:
		- CPHA = 0: data is sampled on the first clock edge of SCK.
		- CPOL = 0: SCK is active high
		- Clock rate = 1MHz
		- LSBF = 0: SPI data is transferred MSB first 
		- BITS = 8: 8 bits per transfer
		- MSTR = 1: SPI operates in Master mode
		1)Look for SD card connected or not, if yes then
		2)Configure SD card in SPI mode, then start SD card's internal
		initialization process.
		3)Read SD card's CID register then decode and display out via 
                COM1

@Directory contents:
	\EWARM: includes EWARM (IAR) project and configuration files
	\Keil:	includes RVMDK (Keil)project and configuration files 
	
lpc17xx_libcfg.h: Library configuration file - include needed driver library for
this example makefile: Example's makefile (to build with GNU toolchain)
spi_sdcard.c: Main program

@How to run:
Hardware configuration:		
			 			
Serial display configuration: (e.g: TeraTerm, Hyperterminal, Flash Magic...) 
	– 115200bps 
	– 8 data bit 
	– No parity 
	– 1 stop bit 
	– No flow control 
	
Running mode:
	This example can run on RAM/ROM mode.
					
Step to run:
    - Step 1: Build example.
    - Step 2: Burn hex file into board (if run on ROM mode) 
    - Step 3: Connect COM1 on the Lincoln board to COM port on your computer
    - Step 4: Run example
	+ Plug in the SD card.
	+ Look at the PC terminal screen to see the information of SD card.  
			
(Pls see "LPC17xx Example Description" document - chapter "Examples > SPI > 
SDCard"	for more details)
		
@Tip:
	- Open \EWARM\*.eww project file to run example on IAR
	- Open \RVMDK\*.uvproj project file to run example on Keil