;==========================================
;PulseCal.pcf Parameters
;==========================================
; This file contains parameters which can be
; modified by the Sonar.Exe application.

;==========================
;Pulse Calibration Sections
;==========================

;This file is used to customize pulses for customer specific transducer characteristics
;Every time a pulse is loaded, calibration values are read from this file (if present).
;
;Two sections are searched, namely:
;  Sub<N><PulseFileName> : Where <N> is the subsystem number and <PulseFileName> is the pulse file name
;                          For example: [Sub20MyPulseFile.spf] would be the section for SSL and
;                                       the pulse MyPulseFile.spf.
;  DefaultSub<N>  : If above is not found.
;
;The following keywords can be provided.  Each may be appended by an OPTIONAL channel number <n>
;if the parameter is to be channel specific.
;
;FreqShift<n>=XXX : Frequency shift of pulse in hertz.  Note that the "optional" <n> is for
;                   testing purposes only and SHOULD NOT be used in a production system as
;                   the system information records and segy structure can report erroneous results
;                   when these channel specific keywords are present.
;GainADC<n>=XXX   : Calibration constant in tenths of a DB
;GainDAC<n>=XXX   : Pulse power modifier where 1000 is unity gain


;==================================================
; [MultipingN] : Multiping algorithm options section
;==================================================
; These values are read once at startup.  N is the "slot number"
; which for MPX systems is 1 and for 4200 are 0 for SSL and 1 for SSH
;
; BlendingAlpha=1800
;    Default value for blending alpha * 1000
; BlendingRange=1500
;    Default value for blending range in MS * 10
; CalPulsePowerStart=300
;    Default start of range for pulse power statistics in MS * 10
; CalPulsePowerEnd=400
;    Default end of range for pulse power statistics in MS * 10
; NegateAftData=0
;    If set to 1 negates aft data in the blending algorithm to test phase shift issues

;===================================================
; [SerialN] : Serial ports
;===================================================
; PressureCalValue=0
;   Calibration value in 1000 * PSI to be subtracted from
;   the pressure readings on this port so that the sensor reads 14700 at sea level