\relax 
\ifx\hyper@anchor\@undefined
\global \let \oldcontentsline\contentsline
\gdef \contentsline#1#2#3#4{\oldcontentsline{#1}{#2}{#3}}
\global \let \oldnewlabel\newlabel
\gdef \newlabel#1#2{\newlabelxx{#1}#2}
\gdef \newlabelxx#1#2#3#4#5#6{\oldnewlabel{#1}{{#2}{#3}}}
\AtEndDocument{\let \contentsline\oldcontentsline
\let \newlabel\oldnewlabel}
\else
\global \let \hyper@last\relax 
\fi

\bibstyle{plain}
\citation{chaffey+mellinger+paul:2001}
\citation{gobat+grosenbaugh:2000}
\@writefile{toc}{\contentsline {section}{\numberline {I}Introduction}{1}{section.1}}
\@writefile{lof}{\contentsline {figure}{\numberline {1}{\ignorespaces Buoy Deployment from the Pt. Sur, December 2, 2002.}}{1}{figure.1}}
\newlabel{Pt_Sur_Deployment}{{1}{1}{Introduction\relax }{figure.1}{}}
\citation{paul+irish:1998,paul+bentley+chaffey+frye:2003}
\@writefile{lot}{\contentsline {table}{\numberline {I}{\ignorespaces Expected sea-states at target deployment sites. Significant wave heights and peak periods are shown.}}{2}{table.1}}
\newlabel{Sea-States}{{I}{2}{Introduction\relax }{table.1}{}}
\@writefile{lof}{\contentsline {figure}{\numberline {2}{\ignorespaces Schematic of the MOOS mooring system and associated benthic network.}}{2}{figure.2}}
\newlabel{MOOS_Cartoon}{{2}{2}{Introduction\relax }{figure.2}{}}
\@writefile{toc}{\contentsline {section}{\numberline {II}MOOS Mooring Description}{2}{section.2}}
\@writefile{toc}{\contentsline {section}{\numberline {III}WHOI-Cable Dynamics Model}{2}{section.3}}
\@writefile{lof}{\contentsline {figure}{\numberline {3}{\ignorespaces Predicted tensions on riser cable in the survival and design sea conditions.}}{3}{figure.3}}
\newlabel{loads-td}{{3}{3}{MOOS Mooring Description\relax }{figure.3}{}}
\@writefile{lof}{\contentsline {figure}{\numberline {4}{\ignorespaces Measured wind and wave conditions during the storm of December 13-16, 2002.}}{3}{figure.4}}
\newlabel{wind_wave}{{4}{3}{MOOS Mooring Description\relax }{figure.4}{}}
\@writefile{lof}{\contentsline {figure}{\numberline {5}{\ignorespaces Measured and predicted tensions in the riser just above the anchor (Mean, max, and standard deviation computed for two minute windows).}}{4}{figure.5}}
\newlabel{anchor_loads}{{5}{4}{MOOS Mooring Description\relax }{figure.5}{}}
\@writefile{lof}{\contentsline {figure}{\numberline {6}{\ignorespaces Measured and predicted tensions in the riser just below the buoy (Mean, max, and standard deviation computed for two minute windows).}}{4}{figure.6}}
\newlabel{buoy_loads}{{6}{4}{MOOS Mooring Description\relax }{figure.6}{}}
\@writefile{toc}{\contentsline {section}{\numberline {IV}Mooring Load Modeling and Comparison to Measurements}{5}{section.4}}
\@writefile{toc}{\contentsline {section}{\numberline {V}Deployment Load Modeling and Comparison to Measurements}{5}{section.5}}
\@writefile{toc}{\contentsline {section}{\numberline {VI}Failure Analysis}{5}{section.6}}
\@writefile{lof}{\contentsline {figure}{\numberline {7}{\ignorespaces Predicted configuration of mooring cable during anchor free-fall deployment, initially the anchor is on the ship at the surface and each successive line shows the mooring cable as the anchor free-falls to the bottom.}}{6}{figure.7}}
\newlabel{positions}{{7}{6}{Deployment Load Modeling and Comparison to Measurements\relax }{figure.7}{}}
\@writefile{lof}{\contentsline {figure}{\numberline {8}{\ignorespaces Measured and predicted tensions during the anchor free-fall.}}{6}{figure.8}}
\newlabel{tensions}{{8}{6}{Deployment Load Modeling and Comparison to Measurements\relax }{figure.8}{}}
\@writefile{lof}{\contentsline {figure}{\numberline {9}{\ignorespaces Model results showing repetitive bending at float attachment points. {\bf  Top:} Time history of cable orientation during wave excitation. {\bf  Middle:} Variation of bend angle and cable tension. {\bf  Bottom} Bend angle versus tension relationship.}}{7}{figure.9}}
\newlabel{Float16}{{VI}{7}{Failure Analysis\relax }{figure.9}{}}
\@writefile{lof}{\contentsline {figure}{\numberline {10}{\ignorespaces Bend angle versus tension relationship for all float locations in all sea conditions.}}{7}{figure.10}}
\newlabel{small_floats}{{VI}{7}{Failure Analysis\relax }{figure.10}{}}
\bibdata{cablerefs}
\bibcite{gobat+grosenbaugh:2000}{1}
\bibcite{chaffey+mellinger+paul:2001}{2}
\bibcite{paul+irish:1998}{3}
\bibcite{paul+bentley+chaffey+frye:2003}{4}
\@writefile{lof}{\contentsline {figure}{\numberline {11}{\ignorespaces Buoy heading and total turns during the deployment.}}{8}{figure.11}}
\newlabel{buoy_turns}{{11}{8}{Failure Analysis\relax }{figure.11}{}}
\@writefile{toc}{\contentsline {section}{\numberline {VII}Buoy Rotation}{8}{section.7}}
\@writefile{toc}{\contentsline {section}{\numberline {VIII}Conclusion}{8}{section.8}}