MBARI SideARM v4 IBoot version 1.7 built on Feb 12 2004 at 10:46:27 Copyright 2001,2002 Intrinsyc Software Inc. Copyright 2004 MBARI CS8900A found at 0x08000300 0 Relocating zImage from 00060000 to C0008000 (len=00100000) Proper ARM zImage ID found. Booting... Uncompressing Linux........................................................... d one, booting the kernel. Linux version 2.4.9-ac10-rmk2-np1-cerf2 (linuxdev@greenflash.shore.mbari.org) (g cc version 2.95.3 20010315 (release)) #24 Mon Jun 6 13:42:46 PDT 2005 Processor: Intel StrongARM-1110 revision 9 Architecture: MBARI SideARM v4 On node 0 totalpages: 16384 zone(0): 16384 pages. zone(1): 0 pages. zone(2): 0 pages. Kernel command line: console=ttySA0 cpufreq=191700 root=1f04 rw init=/linuxrc Calibrating delay loop... 127.38 BogoMIPS Memory: 64MB = 64MB total Memory: 62428KB available (1620K code, 292K data, 64K init) Dentry-cache hash table entries: 8192 (order: 4, 65536 bytes) Inode-cache hash table entries: 4096 (order: 3, 32768 bytes) Mount-cache hash table entries: 1024 (order: 1, 8192 bytes) Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes) Page-cache hash table entries: 16384 (order: 4, 65536 bytes) POSIX conformance testing by UNIFIX Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd v1.8 Journalled Block Device driver loaded JFFS2 version 2.1. (C) 2001 Red Hat, Inc., designed by Axis Communications AB. ttySA5 at MEM 0x80050000 (irq = 17) is a SA1100 ttySA6 at MEM 0x80030000 (irq = 16) is a SA1100 ttySA7 at MEM 0x80010000 (irq = 15) is a SA1100 pty: 256 Unix98 ptys configured SA1100 Real Time Clock driver v1.00 block: queued sectors max/low 41402kB/13800kB, 128 slots per queue RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize Uniform Multi-Platform E-IDE driver Revision: 6.31 ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx loop: loaded (max 8 devices) SA1100 flash: probing 16-bit flash bus Using RedBoot partition definition Creating 5 MTD partitions on "SA1100 flash": 0x00000000-0x00020000 : "I-Boot" 0x00000000-0x00020000 : "RedBoot" 0x00020000-0x00060000 : "Partition 2" 0x00060000-0x00160000 : "Partition 3" 0x00160000-0x00fe0000 : "Partition 4" Linux Kernel Card Services 3.1.22 options: [pm] SA-1100 PCMCIA (CS release 3.1.22) NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP, IGMP IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 4096 bind 4096) NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NetWinder Floating Point Emulator V0.95 (c) 1998-1999 Rebel.com FAT: bogus logical sector size 408 UMSDOS: msdos_read_super failed, mount aborted. FAT: bogus logical sector size 408 FAT: bogus logical sector size 408 Child dir "." (ino #1) of dir ino #1 appears to be a hard link VFS: Mounted root (jffs2 filesystem). Freeing init memory: 64K Setting up RAMFS, please wait... Executing /sbin/init... INIT: version 2.78 booting Mounting local filesystems... mount: tmpfs already mounted on /mnt/ramfs devpts on /dev/pts type devpts (rw,mode=0622) mount: /dev/hda1: unknown device mount: proc already mounted Setting the System Clock using the Hardware Clock as reference... Calculating module dependencies... depmod: /lib/modules/2.4.9-ac10-rmk2-np1-cerf 2/modules.ieee1394map is not an ELF file depmod: error reading ELF header /lib/modules/2.4.9-ac10-rmk2-np1-cerf2/modules. pnpbiosmap: No such file or directory depmod: *** Unresolved symbols in /lib/modules/2.4.9-ac10-rmk2-np1-cerf2/kernel/ drivers/net/loopback.o depmod: *** Unresolved symbols in /lib/modules/2.4.9-ac10-rmk2-np1-cerf2/kernel/ drivers/net/net.o depmod: *** Unresolved symbols in /lib/modules/2.4.9-ac10-rmk2-np1-cerf2/kernel/ drivers/net/net_init.o done. Loading modules: slhc CSLIP: code copyright 1989 Regents of the University of Ca lifornia ppp_generic PPP generic driver version 2.4.1 ppp_async ppp_deflate PPP Deflate Compression module registered bsd_comp PPP BSD Compression module registered cs8900 Cirrus Logic CS8900A driver for Linux (24-Jan-2004) eth0: Registered cs8900_eeprom char device (major #253) eth0: CS8900A rev D at 0xf0000300 irq=47, eeprom ok, addr: 00: C:6A: 0:04:25 eth0: power management support enabled sidearm-wdog sidearm-wdog: version 1.3 [Jun 22 2005 09:57:53] INIT: Entering runlevel: 2 Configuring network interfaces: done. Starting PCMCIA services: cardmgr. cardmgr[60]: starting, version is 3.1.22 cardmgr[60]: watching 2 sockets cardmgr[60]: socket 1: ATA/IDE Fixed Disk Configuring sa1100_gpio gpio port: SA1100 GPIO v1.3 device (10,224): stencil=0x0 00FFFF cardmgr[60]: executing: 'modprobe ide-cs' done. Configuring sa1100_lddio lddio port: SA1100 LDDIO v1.0 device (10,225): stencil= 0x0000FFF Trying to free nonexistent resource hda: SanDisk SDCFB-4096, ATA DISK drive ide0 at 0xf7000000-0xf7000007,0xf700000e on irq 43 hda: 8005536 sectors (4099 MB) w/1KiB Cache, CHS=7942/16/63 Partition check: hda:done. Configuring sa1100_s [PTBL] [992/128/63]pi spi p hda1ort: ide_cs: hda: Vcc = 3.3, Vpp = 0.0 cardmgr[60]: executing: './ide start hda' SA1100 SPI v1.3 device (10,223) cardmgr[60]: + ide.opts configuring default,1,012211E2705T1145 cardmgr[60]: + ide.opts configuring default,1,012211E2705T1145,1 partition 1 done. Configuring Exar serial ports: xr788: version [1.72 (serial wakeup, the saga con tinues) Jun 17 2005 15:05:21] base[10000000] irq[2] firstminor[0] ttySX0 at MEM 0x10000000 (irq = 2) is a 16550 ttySX1 at MEM 0x10000020 (irq = 2) is a 16550 ttySX2 at MEM 0x10000040 (irq = 2) is a 16550 ttySX3 at MEM 0x10000060 (irq = 2) is a 16550 ttySX4 at MEM 0x10000080 (irq = 2) is a 16550 ttySX5 at MEM 0x100000a0 (irq = 2) is a 16550 ttySX6 at MEM 0x100000c0 (irq = 2) is a 16550 ttySX7 at MEM 0x100000e0 (irq = 2) is a 16550 cardmgr[60]: + /sbin/fsck: invalid option -- T cardmgr[60]: + Usage: /sbin/fsck [-panyrcdfvstDFSV] [-b superblock] [-B blocksiz e] cardmgr[60]: + [-I inode_buffer_blocks] [-P process_inode_size] cardmgr[60]: + [-l|-L bad_blocks_file] [-C fd] [-j external_journal] cardmgr[60]: + [-E extended-options] device cardmgr[60]: + cardmgr[60]: + Emergency help: cardmgr[60]: + -p Automatic repair (no questions) cardmgr[60]: + -n xr788: version [1.72 (serial wakeup, the saga continues) Jun 17 2005 15:05:21] base[10000200] irq[3] firstminor[8] ttySX8 at MakMEM 0x10000200e no cha (irq = 3) is a 16550 (irq = 3) is a 16550 fileMEM 0x10000220system cardmgrttySX10 at [60]: + MEM 0x10000240 -y (irq = 3) is a 16550 ttySX11 at AsMEM 0x10000260sume "ye (irq = 3) is a 16550 s" to alttySX12 at l questiMEM 0x10000280ons ca (irq = 3) is a 16550 rdmgr[60ttySX13 at ]: + -cMEM 0x100002a0 (irq = 3) is a 16550 ttySX14 at CheckMEM 0x100002c0 for bad (irq = 3) is a 16550 blocks ttySX15 at and add MEM 0x100002e0them to (irq = 3) is a 16550 the badblock list cardmgr[60]: + -f Force checking even if filesystem is marked clean cardmgr[60]: + -v Be verbose cardmgr[60]: + -b superblock Use alternative superblock cardmgr[60]: + -B blocksize Force blocksize when looking for superblock cardmgr[60]: + -j external_journal Set location of the external journal cardmgr[60]: + -l bad_blocks_file Add to badblocks list cardmgr[60]: + -L bad_blocks_file Set badblocks list cardmgr[60]: start cmd exited with status 1 done. Starting system logger: Starting kernel logger: Starting OpenBSD Secure Shell server: sshd. Starting Boa webserver: boa. hda: hda1 hda: hda1 VFS: busy inodes on changed media. mount: /dev/hda1 already mounted or /mnt/hda busy Setting system date/time to 22/11/2005, 17:48:01. Using /lib/modules/2.4.9-ac10-rmk2-np1-cerf2/kernel/arch/arm/mach-sa1100/registe rs.o Starting SIAM application: Starting longhaul ppp link and syncrhonizing clock done. Serial connection established. Using interface ppp0 Connect: ppp0 <--> /dev/ttySX1 2 ************************************************** ** Intrinsyc Linux (I-Linux) ** ** Copyright 2001,2002 Intrinsyc Software Inc. ** ** Version: 4.4 ** ** Support: http://support.intrinsyc.com ** ************************************************** Warning - secret file /etc/ppp/pap-secrets has world and/or group access surface login: not replacing existing default route to eth0 [134.89.36.200] local IP address 10.1.1.2 remote IP address 10.1.1.1 22 Nov 17:48:08 ntpdate[140]: no server suitable for synchronization found