IO base addresses, interrupts, jumper settings for the 
Laser Raman Single Board Computer (SBC) System

Note, most of these are the factory default settings.
The CPU board and camera do not require special settings. 

-----------------------------------------------------------------
History:
Created: 12:39 PM 5/22/01 D.Cline
Added 7404 quad serial: 1:25 PM 10/16/02 D.Cline
-----------------------------------------------------------------
               		I/O Address	Interrupt/Jumper Settings
-----------------------------------------------------------------
DMA Controller #1       0x00-0x1F     
Interrupt Controller #1 0x20-0x3F
Programmable Timer      0x40-0x5F	0
Keyboard Controller     0x60-0x6F	1
Real time clock, NMI	0x70-0x7F	8
DMA Page Registers      0x80-0x9F
Interrupt Controller #2 0xA0-0xBF
DMA Controller #2       0xC0-0xDF
Clear math coprocessor 	0xF0
	   busy signal
Reset math coprocessor	0xF1
Match processor		0xF8-0xFF	13
Disable watchdog timer	0x120
Enable watchdog timer	0x121
Watchdog		0x122
Fixed disk controller	0x1F0-0x1F8	14/primary 15/secondary
Game port		0x200-0x207
Prototype card		0x300-0x31F
Reserved		0x360-0x36F
Parallel port #1	0x378-0x37F	0x3B/IRQ7
MDA video card		0x3B0-0x3BF
EGA card		0x3C0-0x3CF
CGA card		0x3D0-0x3DF
Floppy disk controller	0x3F0-0x3FF	6
Serial port #1(COM1)	0x3F8-0x3FF	4
Serial port #2(COM2)	0x2F8-0x2FF	3
7404 Quad Serial	
	COM3 (RS485)	0xD400		10 S1=on,S2=off,S3-4=on 
	COM4 (RS232)	0xD800		10 S1-4=off 
	COM5 (RS422)	0xDC00		10 S1=on,S2=off,S3-4=on 
	COM6 (RS422)	0xE000		10 S1=on,S2=off,S3-4=on 
USB					11
PS/2 Mouse				12
PCI backplane card	JP1=open; JP2=2-3; JP3=all open; 
			JP4= 1-2,3-4,5-6,7-8,9-10

PCI SBC card		JP1=1-2,3-4; JP3=2-3; JP4=2-3; JP5=1-2; 
			JP6=3-5,4-6; JP7=3-5,4-6; JP8=1-2; 
			JP9=all open; JP10=1-2

interrupts 5,9,10 reserved	
------------------------------------------------------------
Card Info: see vendor.txt for details
------------------------------------------------------------