COORD is a coordinate conversion program that converts to and
from UTM, decimal degrees and degrees minutes and seconds.  It
can be used interactively with keyboard input and screen output
or will accept input from a file and write to a file.

Input format for UTM data is (A11,I2,I6,I7) identifier(eg.
sample number), zone, easting, northing.  Output has headings
over input values followed by decimal degrees then degrees
minutes and seconds.  User is prompted for an "old" file name
for input and a "new" file name for output.

Input format for decimal degree data is (A11,F9.6,F10.6);
identifier, latitude, longitude.  Output takes the same form as
above.

Input format for degree-minute-second data is (A11,3I3,1X,3I3);
identifier, latitude, longitude.  Output as above.

UTM.INP example:

Sample       UTM           
 1003      174312997608300 
 1020      174451197550550  
 1031      174359597586369  
 1040      165510507574180  
 1048      165507697546610  
 1048      165507607546600  
 1050      165515807566419  
 1058      174251107641810  
 1061      174283007637070  
 1064      174242697611280  
 1067      174252897611359  
 1069      174274217610639  

DECDEG.INP example:

Sample      Latitude Longitude (remove header before processing)
 1003      68.580080 82.685750
 1020      68.065330 82.316510
 1031      68.384570 82.557850
 1032      68.384570 82.557850
 1040      68.277920 85.763990
 1048      68.030760 85.783920
 1048      68.030670 85.784160
 1050      68.208240 85.754960
 1058      68.878860 82.862430
 1061      68.837220 82.779740
 1064      68.604970 82.860340
 1067      68.605960 82.835370
 1069      68.600070 82.782550

DEGMINSC.INP example:

Sample      Latitude Longitude (remove header before processing)
 1003       68 34 48  82 41  8
 1020       68  3 55  82 18 59
 1031       68 23  4  82 33 28
 1032       68 23  4  82 33 28
 1040       68 16 40  85 45 50
 1048       68  1 50  85 47  2
 1048       68  1 50  85 47  2
 1050       68 12 29  85 45 17
 1058       68 52 43  82 51 44
 1061       68 50 13  82 46 47
 1064       68 36 17  82 51 37
 1067       68 36 21  82 50  7
 1069       68 36  0  82 46 57

Since this program was written for Canadian use, there is no
provision for specifying east longitudes (east of the 0 degree
meridian).  I think it works if you enter longitude west of 0
all the way around to 359 59 59.  Check it out.