ADM-XRC Windows 2000/XP driver README
=====================================

1. Supported Operating Systems
------------------------------

This driver runs on the following operating systems:

    o Microsoft Windows 2000
    o Microsoft Windows XP

2. Supported Hardware
---------------------

This driver supports the following cards:

    o ADM-XRC
    o ADM-XRC-P
    o ADM-XRCII-Lite
    o ADM-XRCII
    o ADP-XRCII-N
    o ADM-XRCIIPro-Lite (Bridge revisions 00/01 only)

Please refer to the file "changes.txt" for a detailed list of changes
made between this release and previous releases.

3. Installation Procedure
-------------------------

Follow these steps to install the board:

1.  If you have not already physically plugged the board into your
    machine, please power down and do so. Then power on and boot into
    Windows 2000 and resume at step 2.

2.  If, upon boot, Windows detects the ADM-XRC and automatically prompts
    you to install a driver for it, click "Cancel" and go to step 3.

    If Windows does not prompt you, go to step 3.

3.  Unzip the contents of the ADM-XRC driver .ZIP file to a temporary
    directory on your hard disk, making a note of the path.

4.  Invoke the Windows 2000 Device Manager. This is done as follows:

      a. Select "Start->Settings->Control Panel" from the start menu.

      b. Double click the "System" icon in the control panel.

      c. Select the "Hardware" tab in the System control panel applet.

      d. Click the "Device Manager" button.

5.  If you are upgrading the device driver for an ADM-XRC card which
    is already using the ADM-XRC driver, select the device you want to
    upgrade and then go to step 6.

    If you are installing the device driver for an ADM-XRC card for the
    first time, you must locate the device in the Device Manager. It#
    will usually appear in the Device Manager under the name "Other
    PCI Bridge Device" or similar. Select the device and go to step 6.

6.  Double click the device you selected in step 5. This will bring up
    the device's property page, entitled "<XXX> Properties" where
    <XXX> is the model of the card (eg. ADM-XRCII).

7.  Select the "Driver" tab.

8.  Click the "Update driver" button.

9.  At "Welcome to the Upgrade Device Driver Wizard", click the "Next" button.

10. At "Install Hardware Device Drivers", select the "Display a list of the
    known drivers for this device..." option and click the "Next" button.

11. If the wizard now shows "Hardware Type" and "What type of hardware do you
    want to install", select the "Other devices" icon and then click "Next" and
    go to step 11.

    Otherwise, if the wizard shows "Select a Device Driver", go directly to
    step 11.

12. At "Select a Device Driver", click the "Have Disk" button.

13. In the "Install From Disk" dialog, click the "Browse" button.

14. Navigate to the directory you unzipped the ADM-XRC driver files to
    in step 3, and select the file "admxrc.inf". Then click the "Open" button.

15. In the "Install From Disk" dialog, click the "Ok" button.

16. Back at "Select a Device Driver", click the "Next" button, without
    changing the selection in the "Models" pane.

17. At "Start Device Driver Installation", click the "Next" button.

18. At "Completing The New Hardware Found Wizard", click the "Finish" button.

19. Click the "Ok" or "Close" button in the device's properties page. The
    Device Manager should now updated, showing the upgraded or newly
    installed device (eg. ADM-XRCII).