From: Risi, Michael Sent: Tuesday, June 07, 2011 2:34 PM To: Okuda, Craig Subject: RE: chamber controller boards Attachments: Appendix.Node Firmware.pdf Hey Craig, I think Jose (or someone in his group) can program PIC chips if you give them the hex. I think Thom set them up to do MSP430s. I didn't have the bootloader hex checked in, so I built it can checked it into CVS http://moonjelly.shore.mbari.org/cgi- bin/viewvc.cgi/respirometer/src/modbus_io/bootloader/bootloader.hex I've also attached a first cut of the firmware programming appendix from the documentation Bob and I are working on. You could probably give it to Jose or whoever he has do it and see how far they get with it. It would be good to know for documentation purposes. I already see one probably with the doc, it assumes there is already code on the board. In the case of brand new boards you would start at step 6 in the doc after the bootloader is programmed. Mike From: Okuda, Craig Sent: Tuesday, June 07, 2011 2:09 PM To: Risi, Michael Subject: chamber controller boards Mike, We have a bunch of new chamber controller boards that need to be programmed. I think I can take care of it if you can get me set up with the hex. If you want to take care of it I can give you the boards. Let me know. Thanks Craig Okuda Engineer, Research and Development Monterey Bay Aquarium Research Institute 7700 Sandholdt Road Moss Landing, CA 95039 831 775 1931 voice 831 775 1652 fax craig@mbari.org www.mbari.org