Paul,
The camera housing has (5) 7/16Ó-20 ports and one 1/2"-20 port. The 7/16Ó ports support up to 8 conductors and the 1/2"-20 port supports up to 16 conductors. Right now, these holes are populated with (4) MCBH6F, (1) MCBH8F and a MCBH10F, all of which have titanium bases. The 10 pin has a deck cable with Ethernet. On Tethys we run Ethernet through a 16 pin 1/2"-20 port and it seems to work fine. 

Larry Bird is going to take over the frame construction based on a sketch Ken and I talked about. WeĠre going to add the big Benthos release to the bottom of the frame. 

There is a camera housing for a prosilica that has a MIN10Klong FCR bulkhead that we used for the backup camera on Rover, but I think weĠre supposed to convert that to a fluorometer camera on the Port rack. The housing I think we were going to use for the fluorometer camera has a MCBH8M connector on it right now and is owned by the BIAUV project and has a dome port, so we need to buy the flat port parts and figure out how to reimburse those nice folks over at BIAUV. 

Have a nice weekend,
Brett

***************************************** Brett Hobson
Mechanical Engineer
Monterey Bay Aquarium Research Institute 7700 Sandholdt Road
Moss Landing, CA 95039
(831) 775-1941
<mailto:hobson@mbari.org>hobson@mbari.org