ElfLyseNGoPinUsage
revised:  1/27/15 6PM-2  brent@mbari.org


1	VLCD
2	PC13            Wakeup from sleep or standby mode  (Input: Active HIGH)
3	PC14            LED  (Active HIGH)
4	PC15            [test point]
5	PH0             [reserved for high speed oscillator]
6	PH1             [reserved for high speed oscillator]
7	NRST
8	VSSA
9	VDDA
10	PA0 TIM2_CH1_ETR  I2C1_SDA_Monitor
11	PA1 TIM2_CH2    I2C1_SCL_Monitor
12	PA2		HeaterEnable (Active HIGH)
13	PA3             Temperature Sensor enable (Active HIGH)
14	PA4   DAC_OUT1	HeaterCtrl
15	PA5   DAC_OUT2  reserved
16	PA6   TIM3_CH1  GPIO4 Solenoid PWM0
17	PA7   TIM3_CH2  GPIO5 Solenoid PWM1
18	PB0   TIM3_CH3  GPIO6 Solenoid PWM2
19	PB1   TIM3_CH4  GPIO7 Solenoid PWM3
20	PB2		3P3VSlowStartBypass
21	PB10  I2C2_SCK	CartridgeElfBus
22	PB11  I2C2_SDA	CartridgeElfBus
23	VSS
24	VDD
25	PB12  ADC_IN18	Puck Temperature
26	PB13            Configuration Input 0
27	PB14            Configuration Input 1
28	PB15            Configuration Input 2
29	PA8             15VSlowStartBypass
30	PA9             USART1_TX
31	PA10            USART1_RX
32	PA11            USART1_CTS
33	PA12            USART1_RTS
34	PA13	SWDAT
35	VSS
36	VDD
37	PA14	SWCLK
38	PA15    JTDI                                [pulled up on reset]
39	PB3     JTDO    test point                  [driven on reset]
40	PB4	NJTRST	ProcessPosition (COMP2_INP) [pulled up on reset]
41	PB5             HeaterFault     (Input: Active Low)
42	PB6   TIM4_CH1  GPIO0 Solenoid PWM0
43	PB7   TIM4_CH2  GPIO1 Solenoid PWM1
44	BOOT0           Tie to ground
45	PB8   TIM4_CH3  GPIO2 Solenoid PWM2
46	PB9   TIM4_CH4  GPIO3 Solenoid PWM3
47	VSS
48	VDD