Example Labview code for Wireless MicroStrain Inertia-Link and 3DM-GX2

This example demonstrates the ASPP packet protocol for communicating with a Wireless Inertia-Link or 3DM-GX2.  Please refer to the  "3DM-GX2  Data  Communications Protocol" manual for a complete description of all possible communications commands and modes.  Note that this is only for wireless
devices.  For serial devices, see "USB-Serial Example" vi's

The sample code requires Labview 7.1 or higher.

To use sample code:

	1. Plug your MicroStrain Wireless USB base station into a USB port on
	   your computer.
	1. Plug your Wireless Inertia-Link or 3DM-GX2 into a battery pack and 
	   turn the battery pack on.
	2. Open "Read Accel and Ang Rate Wireless.vi" in LabVIEW
	3. Determine the virtual COM port assigned to the Wireless Base Station 
	   using the Device Manager (in the hardware tab of the "System" control panel).  
	   The virtual COM port will be listed as a "CP210x USB to UART Bridge Controller"
	4. Select the COM port assigned to the base station in the "Serial Port" drop 
	   down contro in the vi.
	5. Click the "Run" arrow in the vi.

Note that the Wireless base station and the Wireless Inertia-Link or 3DM-GX2 need to be on the 
same 802.15.4 "Channel".  The channels are set to be the same at the factory (channel 18).  You
can use the "Inertia-Link" PC application to verify that the base station and sensor are on the
same channel and communicating.