HR: 1340h
AN: OS43A-0530    [Abstracts]
TI: Trace Metal Distribution and Speciation in Pore Water of Hydrothermal Sediments From the Guaymas Basin, Gulf of California
AU: * Morales-Villafuerte, M
EM: maribelmorales@correo.unam.mx
AF: Posgrado en Ciencias del Mar, ICMyL,UNAM, Ciudad Universitaria, D.F., Mexico, D.F 04510 Mexico
AU: Ortega-Osorio, A
EM: aosorio@imp.mx
AF: Instituto Mexicano del Petr˘leo Sistemas Marinos y Costeros, PIMAS, Eje Central L.C. # 152, M‚xico, D.F 07730 Mexico
AU: Wheat, G
EM: wheat@mbari.org
AF: Monterey Bay Aquarium Research Institute, NURP/MLML Marine Operations 7700 Sandholdt Road Building D , Moss Landing, CA 95039 United States
AU: Seewald, J
EM: jseewald@whoi.edu
AF: Woods Hole Oceanographic Institution, MS #4, Woods Hole, MA 02543 United States
AB: Thirteen sediment cores were collected through out direct sampling with the MBARI/ ROV "Tiburon" in the southern trough of the Guaymas Basin in March 2003. Pore water samples from regular 2.5 cm intervals of sediment cores were extracted onboard by centrifugation. The supernatants were collected in clean polystyrene vials and stored at $4\deg$ C until analytical work on shore. Dissolved Fe, Mn, Cu, Pb, Zn and Ni concentrations in extracted fluid samples were analyzed by direct injection of atomic absorption spectrometry. Four zones in the hydrothermal field were classified according to their physical characteristics. A core located away from the influence of active vents was recovered as a background site. The second zone is characterized by low temperatures ($4.2-80\deg$ C) and sediments saturated in hydrocarbons. Sulfides formation and higher temperatures ($4-166\deg$ C) were observed in the third zone. Precipitation of carbonates on top of the sediment characterizes the fourth zone. Concentration of trace metals at the water-sediment interface appears to be the highest, probably due to metal precipitation from the hydrothermal plume, followed by diffusion into the pore water. A decrease in concentration is observed between 5-12 cm depth, suggesting that biological activity is consuming essential metals (zone of bioturbation). Metal concentrations in zones where sulfide phases are rich, exhibit smaller values in pore water (Fe=2.4-3.8 $\mu$mol/kg, Cu=0.6-0.8 $\mu$mol/kg, Pb=1.2-1.5 $\mu$mol/kg, Zn=0.4-0.5 $\mu$mol/kg and Ni= 3.4-4.4 $\mu$mol/kg) relative to samples located at hydrocarbon sites (Fe= 2.7-11.4, Cu= 0.7-1.0 $\mu$mol/kg, Pb= 1.2-2.2 $\mu$mol/kg, Zn= 0.4-0.7 $\mu$mol/kg and Ni= 3.4-5.2 $\mu$mol/kg). At sulfide zones, pH and Eh conditions help to precipitate their stable sulfides as opposed to the hydrocarbon areas, where conditions are not favorable for sulfide formation due to the absence of H$_{2}$S. In general, Fe concentrations in pore water are lower than that of Mn, very likely due to the easier precipitation and greater stability of FeS relative to MnS. As an attempt to reconstruct predominant species and their abundance in the system, aqueous chemical models were applied. The codes EQBRM and SUPCRT92 were run with total concentrations to calculate, concentrations, activity coefficients and thermodynamic properties of aqueous species. Experimental data such as total chloride, total sulfur and measured pH were used in the model. According to the prevailing conditions in the Guaymas Basin, all metals studied form chloride complexes. Iron, lead, and zinc exist mainly as hydroxy complexes, manganese as free ion and copper as CuHS. Speciation results are well supported by the Pearson's hard-soft rule which states that soft metal ion Cu$^{+}$+ bonds with soft bisulfide ligand, likewise, borderline metal ions as Fe$^{2+}$, Mn$^{2+}$, Pb$^{2+}$ and Zn$^{2+}$ bond with chloride, hydroxyl or water ligands. The results reported here provide a greater insight into the behavior of trace metals in pore waters of hydrothermal sediments.
DE: 4835 Inorganic marine chemistry
DE: 3670 Minor and trace element composition
DE: 1050 Marine geochemistry (4835, 4850)
DE: 1065 Trace elements (3670)
SC: Ocean Sciences [OS]
MN: 2004 AGU Fall Meeting