HR: 16:45h
AN: P14A-04 [Abstracts]
TI: Electrical Properties of Ice and Ice-Silicate Mixtures for Mars Exploration
AU: * Stillman, D E
EM: dstillman@boulder.swri.edu
AF: Southwest Research Institute, 1050 Walnut Street, Suite 300, Boulder, CO 80302,
AU: Grimm, R E
EM: grimm@boulder.swri.edu
AF: Southwest Research Institute, 1050 Walnut Street, Suite 300, Boulder, CO 80302,
AB:
We are measuring the complex permittivity of materials relevant to the cryosphere of Mars in order to interpret data
from current missions and to plan future exploration. Measurements are made over a temperature range of 180-
273 K and a frequency range of 1 mHz-1MHz. Materials include "pure" ice, doped ice, and saline ices, either
alone or mixed with reference solids (glass beads, Ottawa sand) or with Mars-regolith analogs (JSC Mars-1,
smectite clays). Initial solute concentrations are always undersaturated.
We find a regular increase in overall conductivity of ice with solute content. This occurs at temperatures above the
eutectic temperature where brine channels are expected to exist and also deeply below the eutectic temperature
where solutes are expected to be almost completely excluded from the ice and precipitated along grain
boundaries. We hypothesize this is a kinetic effect of incomplete segregation, leaving hydrated salts in the former
brine channels. For CaCl2 as a representative solute, initial concentrations must be much greater than 1 mM to
develop significant brine channels.
Mixtures of ice and sand or glass beads behave as expected for two-component systems, with conductivity
dominated by the ice and precipitated solutes. The conductivity of JSC Mars-1 and ice is much lower than
expected and may be due to solute fixation by clays with high ion exchange capacity. We find no evidence of
significantly enhanced conductivity due to thin films of adsorbed or capillary water at subeutectic temperatures.
The dielectric relaxation frequency of protonic point defects in ice was found to vary regularly between a previously
established low value for "pure" ice and a higher limit mapped by us corresponding to 3-10 ppm Cl- saturation of
the ice matrix. We found no changes to the ice relaxation due to mixing with sand; however, JSC Mars-1 caused
the ice relaxation frequency to decrease, presumably because even trace Cl- was removed and not incorporated
into the ice matrix.
These results have implications for surface-penetrating radars and microbial habitability of Mars. The DC
conductivity of saline ice is too small to cause significant attenuation of sounding radars and the dielectric
relaxation is also inefficient unless the ice is warm. The low DC conductivity even for ice-silicate mixtures where
water layers of a few monolayers are present further implies that microbes in the cryosphere cannot transport
nutrients and waste in quantities sufficient even for dormancy: warming cycles to periglacial conditions are
necessary to activate brine channels and solute transport. These measurements can also be used to help
interpret the simple electrical properties measurements that will be made by the Phoenix lander. Ongoing
investigation includes the effects of dielectric relaxations due to bound water and interfacial polarizations on radar
loss, and testing the ability to map subsurface ice using the strength of the dielectric relaxation.
DE: 3914 Electrical properties
DE: 5422 Ices
DE: 5462 Polar regions
DE: 6225 Mars
SC: Planetary Sciences [P]
MN: 2007 Fall Meeting