Dual Laser Mounting Bracket
- CREATES AND MAINTAINS PARALLEL BEAMS
- EXCELLENT FOR SCALING AND MEASUREMENT
- DESIGNED FOR USE WITH SEALASER 100
|
|
|
Dual Laser Mounting Bracket |
|
|
| |
The Dual Laser Bracket is designed to hold two lasers and provide for 10 cm parallel beam alignment. Turning the two eccentrically bored balls at either end of each laser adjusts the beams. The bracket has four mounting holes tapped for ¼-20 screws. The bolt pattern is 3"x 1.75". The bracket can also be mounted to a camera by placing the camera in one of the two radii at the top and bottom of the unit. A hose clamp can be strapped around the camera, through the slot in the center of the bracket, and over the inner spacer.
MECHANICAL Housing Material: Acetal plastic (Delrin) Length: 14.6 cm (5.75 in.), without SeaLasers 15.8 cm (6.21 in), with Sealasers Height: 4.8 cm (1.90 in.) Width: 14.8 cm (5.84 in.) OTHER Distance between beams: 10 cm (3.94 in.)
 |
Specifications subject to change without notice.
Rev. 01/06/00 |
