External Bus Monitor Revisions


----------------------
8/09/2006   CS
----------------------
-Add 5W1 connector for seawater ground
	1)bottom right edge of board
-Add 1 pair of 400Vin to J4
-Change 400V and 48V pane nets on internal layers to allow for J4 change
	1)old inner2&3 = 400_V1 & 400V_OUT, new = 400_V2 & 400V_OUT
	2)old inner4&5 = 400_V2 & 400V_OUT, new = 400_V1 & 400V_OUT
-reduced corners of internal planes, widened
-Added testpoint labels
-Bottom mount components to get 2xx nomenclature
-Renumbered R's and C's on top layer
-grouped part #'s for RC ladders
-Add RC output filter to GF_MON



----------------------
8/03/2006   CS
----------------------
-Group ground fault functionality on page 1 of schematic
-Add RC ladder ground referencing page 2
-Resistors to 0805 package
-Despiking cap's to 0805 package
-Add 8W8 connector for 2 pair 48Vin and 1 pair 400Vin, (J4)
-Add 5W5 connector for 2 pair 48Vout, (J6)
-Add 8W8 connector for 4 pair 400Vout, (J5)
-Linearize 48V and 400V flow across board
-move to 6 layer board
	1)48V and 400V nets have either FR4 or minimum of 225 mil separation
-2 headers added for testpoint access when installed in chassis
	1)digital control signals in, (J7)
	2)analog monitoring signals out, (J8)
-other testpoints to surface mount on edge of board
-eliminate middle top and bottom mount holes, (room for connectors)
-add middle left and right side mount holes