Setup of Aminet110H video decoder [initial draft : 7-Dec-2010]

Settings for this are found in the 'toro sub nets.xls' file in the \ProjectLibrary\Microwave directory.
Programming of this unit is done with the wireless IR "Amino" keyboard.

Connect breakout cable to the Audio Visual Out mini DIN connector on decoder box.  Connect the yellow RCA jack to a video monitor using whatever adaptor is required (RCA-F to BNC-F for SE Lab).
Apply power to the decoder.

Type alt-M to enter management mode.
Password is 'leaves'

This brings up the Main Menu

Select "Browser Setup"
IGMP (Internet Group Multicast Protocol) 
225.1.1.200 is MARS
225.1.1.100 is Lobos
225.1.1.101 is Flyer
225.1.1.102 is Aquarium
225.1.1.105 is 2nd Lobos (?)
Port 50000 for all

In "Home Page" box, enter correct address, for example, MARS is as follows:
igmp://225.1.1.200:50000

"Help Page" box should be blank.
Accept Cookies.
Do not use Proxy.

When change is made to correct the setting, you must enter a password to save the change.
Enter "snake" in password box.

Return to Main Menu and select "Channels"
Select "0-99" and make sure all are blank.

Return to Main Menu and select "Video Setup"
TV Standard should be NTSC-M
Output Format should be Composite (+ SVideo?)
IGMP timeouts should be 0.

Return to Main Menu and select "Network Configuration"
In "DHCP Info" box, select Do Not Use DHCP
Enter IP address (134.89.45.46 for MARS video at MBA)
Enter Netmask (255.255.255.0)
Enter Gateway (134.89.45.1)

Save all entries each time by entering 'snake' in the password box.
Return to the Main Menu and then hit the <esc> key to exit management mode.
Remover power.
Plug network cable into Ethernet Port 1.
Reapply power.  Desired channel should be displayed on monitor.