Mt. Toro Seatel remote operation

Open two windows.
All commands are case sensitive.

<>WINDOW 1<>
telnet "wave".
Run "tail -f /u/mccann/data/lobos_pos".
This will give you the lat/lon of the PL.
Cut the last lat/long numbers onto the clipboard.

<>WINDOW 2<>
telnet "coral".
Switch to directory "troll" by typing "cd /usr/troll".
Run the range/bearing script by typing "rb -t [lat/lon]".
       (Paste the lat/lon from the clipboard)
This will give you the distance from Mt Toro (unimportant), the
bearing to Mt Toro (#1) from the PL and the recip heading from 
Mt. Toro to the PL (#2).
Call the PL, X1607, and give them their daily number (#1).

Run the smart switch script by typing "wf-seatel"
You will see the following:

 This is the program to connect to the smart switch at MCOE on Mt. Toro.
 'P' shows AZ/EL, 'A' sets AZ, 'E' sets EL.
 'B' sets heading, 'M' sets tracking defaults.
 '%' shows signal strength, should be in the DXX range.

 Type ESC Cntrl-B  B to get to the PL Seatel.
 Elevation 090 seems to be the right number.
 Heading should be 312.5 degrees (View with 'H').
 X001 Y000 N040 for tracking defaults (View with 'M').

 Type ESC Cntrl-B C to get to the WF Seatel.
 Elevation 020 seems to be the right number.
 Heading should be 312.5 degrees (View with 'H').
 X001 Y000 N040 for tracking defaults (View with 'M').

 Type ESC Cntrl-B D to access the DGPS Digipeater.

 Type ESC Cntrl-B E to access the Knox switch.

 Type ESC Cntrl-B E Then type ESC Cntrl-B A when you are done.


*Trying...
*Connected to coupterm.shore.mbari.org.
*Escape character is 'Cntrl ]'.   

If the connection is refused, the Lantronix in the cupola must be power 
cycled. Call Mike Mccann, X1769, and have him restart his process after it 
is reset.

Upon opening the PL Seatel, you must enter "E9.0" immediately. It gets lost!
Upon opening the WF Seatel, you must enter "E2.0" immediately. It gets lost!
Enter "P" will give you the Toro Seatel stats, AZ/EL. (EYYYAXXXX)
Correct azimuth by entering "AXXXX" (Where XXXX (no decimal pt) is #2
from above).

DO NOT ENTER "B" unless you know what you are doing. This will reset the 
heading (H) to zero (0) or whatever number you follow "B" with.
DO NOT ENTER 'C' or 'D', this switches automatic/manual mode!
DO NOT ENTER 'M', this changes parameters!

Enter "ESC Cntrl-B E", then "ESC Cntrl-B A" when you are done.
Enter "Cntrl ]", then type "quit" to close the session.
Do not leave the session open, noise will currupt the Seatel and undo all your 
changes, and spoof the Seatel more.