-9999 Mastercam-to-IOF: Operation #1 (Lathe Face) -9998 Mastercam-to-IOF: Operation #2 (Lathe Rough) -9997 Mastercam-to-IOF: Operation #3 (Lathe Finish) -9996 Mastercam-to-IOF: Operation #4 (Pecking Cycle) -9995 Mastercam-to-IOF: Operation #5 (Pecking Cycle) -9994 Mastercam-to-IOF: Operation #6 (Pocket (Standard)) -9993 Mastercam-to-IOF: Operation #7 (Thread Mill) -1000 Reading Operation and Toolpaths from NCI database -9 Processing IOF machine motion data -1 General 1 Operation 1 (Lathe Face) 2 Operation 2 (Lathe Rough) 3 Operation 3 (Lathe Finish) 4 Operation 4 (Pecking Cycle) 5 Operation 5 (Pecking Cycle) 6 Operation 6 (Pocket (Standard)) 7 Operation 7 (Thread Mill) 2000 Validating work offset information 2040 Processing Reference Position Data. 20010 Motion Timing Computation. -1 7 operations chosen for BNCI-to-IOF conversion. Info 0 -1 7 operations chosen for BNCI-to-IOF conversion. Info 0 -9 Processing document... Info 0 -9 Preprocessing stream 0... Info 0 1 Operation 1 (Lathe Face) Info 0 1 Classifying Operation Type. Info 1 1 Invoke Turning Pre-Processor. Info 1 2 Operation 2 (Lathe Rough) Info 0 2 Classifying Operation Type. Info 1 2 Invoke Turning Pre-Processor. Info 1 3 Operation 3 (Lathe Finish) Info 0 3 Classifying Operation Type. Info 1 3 Invoke Turning Pre-Processor. Info 1 4 Operation 4 (Pecking Cycle) Info 0 4 Classifying Operation Type. Info 1 4 Invoke face polar (G12) Mill Pre-Processor. Info 1 4 Invoke long hand polar Mill Pre-Processor. Info 1 5 Operation 5 (Pecking Cycle) Info 0 5 Classifying Operation Type. Info 1 5 Invoke face polar (G12) Mill Pre-Processor. Info 1 5 Invoke long hand polar Mill Pre-Processor. Info 1 6 Operation 6 (Pocket (Standard)) Info 0 6 Classifying Operation Type. Info 1 6 Invoke face polar (G12) Mill Pre-Processor. Info 1 6 Invoke long hand polar Mill Pre-Processor. Info 1 7 Operation 7 (Thread Mill) Info 0 7 Classifying Operation Type. Info 1 7 Invoke face polar (G12) Mill Pre-Processor. Info 1 7 IGAC3001 ArcCheck error: The arc length is too small. The tool path generator has produced an arc whose chord length is smaller than the allowable length. (length = 0.000230601, threshold = 0.0005). This issue has been resolved by skipping the arc. Warning 0 7 Invoke long hand polar Mill Pre-Processor. Info 1 20010 Beginning operation timing phase. Info 0 7 Ending operation timing phase. Info 0