Skip to content

Restock the Sampler

After you load new pucks or replace a supply, tell FIDO so it can count the pucks and reset its supply counters.

1. Load the hardware

Hardware — to be written

How to load pucks and how to replace the preservative, decontaminant and nitrogen supplies. See Consumables.

2. Run Restock

  1. Make sure no sample is running and pause the schedule if a sample is due soon (see Schedule Sampling).
  2. Open the Management page and click Restock Sampler.
  3. Tick only the steps for what you changed:

    Section Tick When
    Pucks Count pucks You added or removed pucks
    Preservative Reset counter and Prime You installed a new bag or bottle
    Decontaminant Reset counter and Prime You installed a new bag or bottle
    Nitrogen Reset counter You replaced the nitrogen supply
  4. Click Run Restock.

All boxes start ticked. Untick what you didn't change.

Warning

Prime pumps fluid through the lines. Make sure the supply is connected and the lines are in place before you run it.

The sampler counts the pucks itself. Number of Stocked Pucks on the Device page updates when it's finished.

To confirm

Whether a user should ever untick Reset counter but keep Prime (or the other way around), and what happens if the counted pucks don't match what was loaded.